SPK - ZEBRONICS PORTABLE BLUETOOTH SPEAKER (PRIMA PRO)

Insert the USB Drive into the USB port. The speaker will detect the USB Drive and the audio file will be played automatically.

Connect one end of a 3.5mm cable to the speaker and connect the other end of the cable to an audio source. The tracks from the audio source can be heard through the speaker.

Switch the speaker to BT mode. 5 Scan for nearby BT devices on your mobile device. Tap on "ZEB-PRIMA PRO" to connect.

Turn on two ZEB-PRIMA PRO speakers. Double click the "Bluetooth button" on any one speaker to activate TWS mode. After a few seconds, both speakers will be connected successfully. Search for "ZEB-PRIMA PRO" on your mobile to connect. Note: You need to make the TWS connection first, then make the Bluetooth connection with the mobile phone.

Connect your first speaker via Bluetooth. Short-press the Auracast button to enable broadcast mode; this speaker will act as the master unit. The master speaker will automatically search for and connect to other Auracast-enabled Zebronics speakers, which will function as slave units.

Use the Anti-freeze reset button located near the speaker's ports. Alternatively, press and hold the BT button and the Bass Enhancement button simultaneously for 4 seconds to restore the factory settings.

Short press the RGB Light Button in the MIC Volume Knob to switch between the RGB Lighting modes. Long Press the button to toggle ON/OFF the RGB Modes. You can also control lighting through the ZEB VIBE CONTROL App.

In the MIC/GT Interface, pull the switch up to enable MIC. Push the switch down to enable Guitar Input.

Observe the Battery Level Indicator LEDs. There are five LEDs, each representing 20%, 40%, 60%, 80%, and 100% of the battery level.